ServicesConcrete Pool Decks
Concrete Pool Decks in Buena Park
We remove worn pool decks and replace them with new concrete that has a slip-resistant finish, a slope carrying water away from the pool and a flexible joint at the coping. Your pool stays covered throughout, and we clean up at the end of every workday.
A New Deck Built Around the Water
A pool deck takes more abuse than most flatwork. It stays wet, it sees chlorine and salt, bare feet cross it all summer and it sits against a pool shell that moves differently than the slab beside it. That is why we treat a deck as its own kind of pour, not a patio that happens to be next to water.
The details that matter are specific. We slope the surface roughly an eighth to a quarter inch per foot away from the pool so splash water and rain drain to the yard or a deck drain instead of back over the coping. We leave an expansion joint between the deck and the coping and seal it with a flexible sealant, so the two can shift without cracking each other. We cut control joints at planned spacing so the slab cracks where we tell it to, in a straight line, not across the middle of a lounge area.
Under the hot Southern California sun, finish choice matters as much as structure. A broom or salt finish grips wet feet, and a lighter-colored surface stays cooler to walk on than dark concrete. We have been pouring decks like this for more than 15 years, and we keep the pool, the equipment pad and your plants clean the whole way through.
What Your Pool Deck Project Includes
Pool protection first
Before any demolition, we cover the pool with heavy plastic and seal it at the coping. Concrete dust and slurry raise the water's pH and can stain plaster, so keeping them out matters more here than on any other job.
Demolition and haul-off
We break out the old deck, load the debris and haul it away. Saw cuts along the coping are done wet to keep dust down.
Base, steel and joints
We regrade and compact the base, then lift the rebar grid onto plastic supports so it ends up embedded at mid-thickness, where it resists cracking best. We also lay out the expansion joint at the coping and the control joints across the deck.
Slip-resistant finish
Choose a broom finish, a rock salt finish or a textured topcoat that runs cooler underfoot. If you want a decorative look, we can also pour stamped concrete with a texture that still grips.
Daily cleanup
Each evening we sweep, rinse tools into a contained washout and keep paths clear so you can use the rest of your home normally.
Signs It Is Time for a New Pool Deck
- Water flows toward the pool
- If puddles drain back over the coping, the deck has settled or was never sloped correctly. That water carries dirt and fertilizer into the pool and soaks the soil next to the shell.
- Cracks across the slab
- Random cracks that wander between joints usually mean thin concrete, missing steel or a poorly compacted base. Once they spread, a new pour is the lasting answer.
- Lifted or sunken sections
- A slab edge that sits higher than its neighbor is a trip hazard for wet, barefoot kids.
- Slick or worn surface
- Old troweled finishes polish smooth over time and become slippery when wet. A worn, flaking coating also scratches feet.
- A gap at the coping
- When the joint between the deck and the coping opens up or the sealant is gone, water gets behind the bond beam every time someone splashes.
How a Pool Deck Job Runs
- 1
Walk-through and measurements
We measure the deck, check how water drains today, note equipment, drains and gate access, and talk through finishes. You get your quote by phone or in person with each part of the work listed.
- 2
Cover, protect and demolish
We seal off the pool, lay protection over planters and the equipment pad, then remove the old concrete and haul it away.
- 3
Prepare the base and forms
We grade for slope, compact the base, set forms and rebar, and place the expansion joint material along the coping. Any required permit or inspection happens at this stage.
- 4
Pour and finish
We place the concrete, screed it to grade, and apply your chosen finish at the right point in the set so the texture holds. Control joints are tooled or saw-cut the same day or next morning.
- 5
Cure, seal and hand back
We keep the slab moist while it cures, seal the coping joint with flexible sealant and do a final rinse. The plastic comes off the pool only after the deck is clean.
What Moves the Price of a Pool Deck
We price every deck from its own measurements and site conditions. The largest differences come from how much old concrete has to come out, how hard the backyard is to reach and which finish you choose. Each item appears on its own line in your quote, so the total is easy to follow.
- Deck area and pool shape
- Square footage sets the amount of concrete and labor. A curved freeform pool takes more forming and hand finishing than a straight-sided rectangle.
- Removal of the old deck
- Thick slabs, heavy rebar or an old deck poured over an even older one add breaking time and disposal weight.
- Backyard access
- A narrow side yard may mean pumping the concrete over the house or wheeling it in, and both change crew time and equipment.
- Finish and drainage
- A broom finish costs less than stamped work or a cool topcoat. Adding deck drains or a channel drain adds material and labor.
Pool Deck Questions
- Will concrete or dust end up in my pool?
- We cover the pool before demolition and keep the cover on until the deck is cleaned. Saw cuts are made wet, and washout water goes into a contained area, not your yard or pool. If any slurry does reach the water, we tell you so it can be balanced before anyone swims.
- How soon can we walk on the deck and use the pool?
- Light foot traffic is usually fine after a day or two. Patio furniture should wait about a week. Concrete keeps gaining strength for weeks, so we give you specific timing based on the weather during your pour.
- Which finish is least slippery?
- A broom finish and a rock salt finish both give good grip on wet feet. Textured cool topcoats are also grippy and stay more comfortable in the sun. Smooth troweled concrete is the one to avoid around water.
- Why do you leave a joint at the coping?
- The pool shell and the deck expand and settle at different rates. A filled, flexible joint lets them move independently, which keeps the deck from pushing on the coping and cracking it.
- What credentials and coverage come with the work?
- Our company holds a license from the California State License Board (CSLB), and our pool deck work comes with a 1-year warranty. We go over exactly what the warranty covers when we quote your job.
Plan Your New Pool Deck
Tell us about your pool, the deck you have and the finish you want. We will set up a walk-through and explain how we protect the water and your yard during the work.